Feature:
1: The air lift connector has a 45-degree curvature, which makes the water flow more smoothly, which can be driven by a small air pump.
2: Four transparent suction cups, more reliable. It can be used normally even if you change 1-2, the bracket is all acrylic, which is convenient for observation.
Introduction:
100% brand new 50MM short version ornamental fish egg incubator. The purpose of the incubator is to allow fresh water to circulate on the cichlid eggs that have been separated from their parents. Fresh flowing water can allow the eggs to develop in an oxygen-rich environment. Chemicals are needed to inhibit the development of molds and fungi. The gentle rolling motion can simulate the normal hatching of these fish, so it is necessary to roll your cichlid eggs.
Description:
Product Name: Incubator Kit
Material: Acrylic
Color: White
Size: 25x5cm
Applicable scenarios: fish tanks, aquariums, etc.
Method of deducting eggs:
1 Take out a basin of water from the tank (must be water in the tank).
2 Carefully remove the female fish.
3 Hold the fish with its head facing forward.
4 Use your nails to buckle the teeth of the lower jaw of the fish. Be careful not to buckle the lower lips.
5 Buckle downward and forward. Note that both downward and forward alone are harmful to the fish. Add one more point in the water.
6 Keep your mouth open, keep steady, and move against the direction of the fish's head in the water.
7 Repeat the exercise until all the eggs are out.
8 Note that if the female fish is removed, catch it back in time, otherwise she will immediately swallow the eggs in the basin back into her mouth.
9 Take the female fish out. Look at the mouth of the fish with your eyes to make sure it is clean. Put it back in the tank.
10 Put the roe into the incubator (if it is a fry, put it into the isolation box)
Reminder: If it is a small seedling, put it in the isolation box. Put the isolation box in the tank where there is sufficient water flow and sufficient oxygen. Pay special attention to the whole process. Be sure to use the original tank water for about 1 day after the egg is detained. For safety, do not change the water.
Packing list:
1 x Main incubator
4 x Suction Cups
1 x Gas lift chamber
1 x Biochemical cotton
1 x Air Tube
1 x Sand head
Note:
The color deviation is subject to actual system configuration and slight dimension difference is allowed due to manual measurement.
