DC 12V Universal Car Electric Turbine Power Turbo Charger Tan Boost Air Intake Fan

This kind of modification is more violent, and the wind pressure is very high. Suitable for customers who require high performance improvement 70mm Top Violent Supercharging Fan Automobile Supercharging Violent Fan Automobile Refitted Pumping Fan, Special Fan for Automotive Electric Turbine Motor Length 10cm Motor Material Metal Shell Blade Metal Leaf Moderate volume and easy installation 100% original authentic product. ************************************************** 90%New Old items shown the photo. Turbine front and back plastic material CAP removable if you don`t want it. Notice: Don`t wiring the turbine directly to Power.This have to connected up Driver ESC electronic speed control. Don`t Let the turbine contact with car iron part (because of other iron part also negative electrode \-\) ************************************************** TURBO parameters： Speed: 35000 rpm Input Voltage: DC 12V Maximum current: 24A Maximum power: 380W Maximum thrust: 1200g KV value: 3100 Maximum speed: 52000RPM (loud voice) Number of poles: 6 Winding connection: Y-type 5-wire and around ************************************************** Model: 40A ESC(Electronic Speed Control) 40A (2-4S) technical parameters: Power supply mode: direct current. Phase number: for brushless three phase motor drive Continuous output current: 40A Input voltage: 7.2-12V Maximum applicable motor capacity: 480W Maximum output current: 50A Driving current: 40A (Max:50A/10S) BEC:5V3A Compatible signal frequency: 30Hz - 500Hz ************************************************** Model: 50A ESC(Electronic Speed Control) 50A (2-3S) technical parameters Power supply mode: direct current. Phase number: for brushless three phase motor drive Continuous output current:50A Input voltage: 7.2-14.8V Maximum applicable motor capacity: 600W Maximum output current: 65A Driving current: 50A (Max:65A/No less than 10S) BEC:5V5A Compatible signal frequency: 30Hz - 500Hz ************************************************** Warning 1.The turbine must be connected to the ESC 2. Power off first 3. Esc switch knob is screwed to the minimum position. 4. To connect dc 12 volt battery. ************************************************** Please operate according to the following operation mode: The first step is to insert the three-needle plug into the out position of the tester. The white line is on the s-pole.There are three rows of arbitrary plugs in one row, and the knob is set to the minimum position.Weld the three rows of motor wires with the three wires adjusted by electricity without any color difference.After welding, tape should be wrapped to prevent short circuit. Second step,Connect a DC 12 volt power supply to an electrically regulated red connection positive pole and a black connection to the negative pole. After power on, the motor will make a sound, stop ringing after a few seconds, then slowly twist the knob of the tester to start the motor, Third step，the normal operation of the wind is from the motor tail discharge, if not to indicate that the motor reversed, the need to remove two of the motor wires to adjust and then welding,then the motor works properly.